Includes a black rubber boot and 2 neodymium magnets for securely holding  to your machine. 

Requirements: 

• Officially supported version of Path Pilot is current version and 1 version prior, i.e. with current version being 2.8.0, version 2.7.4 and 2.8.0 will be supported by Made With CNC.*
  
• 1 Available USB Port on your Path Pilot Controller

 *the unit should technically work on Path Pilot 2.5.1 and above.

Machine Compatibility:

Full plug and play compatibility for machines that Tormach does not offer an Operators Console for, it at Tormach's discretion. Please email support@madewithcnc.com if you have any questions. 

• All M Series Mills
• All 770 Series Mills
• PCNC 440 Mill
• All Series 3 Mills (PCNC 1100 serial number 2000 or higher)
• Series 2 Mills that have the Series 3 Motion Control Upgrade installed*
• 15L Slant Pro and 8L Lathes
• 24R
• 1300PL Plasma Table

 *future testing planned to confirm if Series 2 Mills without the Series 3 Motion Control Upgrade are compatible.

Features:

• Feed Override (0% - 200%) 
• Spindle Speed Override (0% - 200%) 
• Rapid Override (0% - 100%) 
• Jog Axis Selection (None, X, Y, Z, A)
• Jog Step Selection (.0001, .001, .01)
• Jog Wheel
• Cycle Start Button
• Feed Hold Button
• Program Stop
  
• Coolant On/Off*

*for machines without coolant, the Coolant On/Off button is non-operational

Please note: Made With CNC products are not tested, sponsored, endorsed, nor approved by Tormach Inc.